All devices are preconfigured from the end of Day 17’s lab (SW2 has been replaced with a multilayer switch):
Hosts are in the correct VLANs.
SW1-SW2 are connected via trunk.
R1-SW2 are connected via ROAS.
1. Replace the ROAS configuration on R1-SW2 with a point-to-point Layer 3 connection.
Use the IP addresses given in the network diagram.
Configure a default route on SW2, with R1’s G0/0 interface as the next hop.
2. Configure SVIs on SW2, one for each VLAN.
Assign the last usable IP address of each subnet to the appropriate SVI.
3. Test inter-VLAN connectivity by pinging between VLANs.
4. Test connectivity to the Internet by pinging 220.127.116.11
*R1 has a route to the Internet, but not to the LAN, so you’ll have to configure it
**In the video I didn’t configure the routes, but I know you can do it on your own 😉
Switch – SW2
default interface g1/0/2
ip address 10.0.0.193 255.255.255.252
ip route 0.0.0.0 0.0.0.0 10.0.0.192
interface vlan 10
ip address 10.0.0.62 255.255.255.192
interface vlan 20
ip address 10.0.0.126 255.255.255.192
interface vlan 30
ip address 10.0.0.190 255.255.255.192
ip route 0.0.0.0 0.0.0.0 10.0.0.194
Router – R1
no interface g0/0.10
no interface g0/0.20
no interface g0/0.30
default interface g0/0
ip address 10.0.0.194 255.255.255.252